|本期目录/Table of Contents|

[1]朱本瑞,韩文秀,孙振平,等.考虑波纹板承载的导管架平台生活楼结构设计[J].天津大学学报(自然科学版),2018,(05):533-538.[doi:10.11784/tdxbz201703090]
 Zhu Benrui,Han Wenxiu,Sun Zhenping,et al.Structural Design of Living Quarter on Jacket Platform Considering Corrugated Panel Bearing Capacity[J].Journal of Tianjin University,2018,(05):533-538.[doi:10.11784/tdxbz201703090]
点击复制

考虑波纹板承载的导管架平台生活楼结构设计()
分享到:

《天津大学学报(自然科学版)》[ISSN:0493-2137/CN:12-1127/N]

卷:
期数:
2018年05
页码:
533-538
栏目:
论文
出版日期:
2018-05-15

文章信息/Info

Title:
Structural Design of Living Quarter on Jacket Platform Considering Corrugated Panel Bearing Capacity
文章编号:
0493-2137(2018)05-0533-06
作者:
朱本瑞1 韩文秀1 孙振平2 李润野1 黄锡玲1 杨树耕1
1. 天津大学水利工程仿真与安全国家重点实验室,天津 300072; 2. 中海石油(中国)有限公司上海分公司,上海 200335
Author(s):
Zhu Benrui1 Han Wenxiu1 Sun Zhenping2 Li Runye1 Huang Xiling1 Yang Shugeng1
1.State Key Laboratory of Hydraulic Engineering Simulation and Safety, Tianjin University, Tianjin 300072, China
2.Shanghai Branch of CNOOC Ltd., Shanghai 200335, China
关键词:
生活楼 波纹板 SACS 强度增强系数 刚度增强系数
Keywords:
living quarter corrugated panel SACS strength enhancement coefficient stiffness enhancement coefficient
分类号:
TE54
DOI:
10.11784/tdxbz201703090
文献标志码:
A
摘要:
为有效降低导管架平台上部组块重量, 针对导管架平台120人生活楼结构, 提出生活楼外壁取消斜撑、直接采用波纹板进行承载的结构设计方案.针对生活楼局部框架波纹板模型, 探讨SACS模拟波纹板结构的方法和波纹板网格划分密度, 在此基础上, 采用SACS建立生活楼整体结构的有限元模型, 对88种载荷组合工况进行计算, 引入强度增强系数和刚度增强系数, 深入分析对比波纹板与斜撑对生活楼结构的强度和刚度贡献.结果表明, 波纹板对结构的刚度贡献大于斜撑, 对大部分杆件的强度贡献亦大于斜撑, 因此在考虑波纹板承载的基础上, 生活楼外壁取消斜撑的结构设计方案是可行的.
Abstract:
Based on a 120-people-living quarter on jacket platform,a new structural design of living quarter bulkhead that corrugated panels were directly used to carry loads instead of diagonal bracings was proposed in order to decrease the weight of topside. Based on a local corrugated frame panel,the method of modeling a corrugated panel and the mesh size of finite element in SACS were discussed. Furthermore,three kinds of finite element model of the whole living quarter were built by SACS and structural stress and deformation were analyzed under 88 kinds of load combinations. In order to make a comparison of contribution to structural strength and stiffness between corrugated panel and diagonal bracing,strength enhancement coefficient and stiffness enhancement coefficient were introduced. The analysis showed that the stiffness contribution rate of corrugated panels was slightly bigger than that of diagonals bracing and the strength contribution of corrugated panels to most of beams was also bigger than that of diagonal bracings. Generally,the structural design of living quarter bulkhead was feasible.

参考文献/References:

[1] 王胜, 席时春, 侯晓蕊. 板架结构生活楼的技术与应用[C]//2010全国钢结构学术年会. 北京, 中国, 2010:291-296.
Wang Sheng, Xi Shichun, Hou Xiaorui. Technique and application of grillage living quarter [C]//2010 the National Steel Construction Academic Essays. Beijing, China, 2010:291-296.
[2] 李利飞, 徐田甜, 张建勇. 浅谈我国海上固定式平台生活模块的现状和发展趋势[J]. 船海工程, 2008, 37(3):87-91.
Li Lifei, Xu Tiantian, Zhang Jianyong. The status quo and development trend of the living quarters for fixed offshore platform in China[J]. Ship & Ocean Engineering, 2008, 37(3):87-91(in Chinese).
[3] 康思伟, 朱本瑞, 李润野. 平台生活楼适应SPMT运输的结构设计[J]. 天然气与石油, 2017, 35(1):119-124.
Kang Siwei, Zhu Benrui, Li Runye. SPMT transportation structural design for platform living quarter[J]. Natural Gas and Oil, 2017, 35(1):119-124(in Chinese).
[4] 苏新福, 曹志强, 徐青, 等. 海上固定平台生活楼的设计[J]. 中国造船, 2007, 48(增刊):253-260.
Su Xinfu, Cao Zhiqiang, Xu Qing, et al. Living quarter design of offshore fixed platform[J]. Shipbuilding of China, 2007, 48(Suppl):253-260(in Chinese).
[5] 宋杰, 许莲, 李春萌. 海上固定平台生活楼模块舾装减重影响因素分析与建议[J]. 海洋工程装备与技术, 2016, 1(3):207-212.
Song Jie, Xu Lian, Li Chunmeng. Analysis and advice on impact factors of outfitting weight reduction for offshore fixed platform living quarters module[J]. Ocean Engineering Equipment and Technology, 2016, 1(3):207-212(in Chinese).
[6] Nilson A H, Ammar A R. Finite element analysis of metal deck shear diaphragms[J]. Journal of the Structural Division, 1974, 100(4):711-726.
[7] 郭彦林, 张庆林. 波折腹板工形构件截面承载力设计方法[J]. 建筑科学与工程学报, 2006, 23(4):58-63.
Guo Yanlin, Zhang Qinglin. Design method of section bearing capacity of I-type member of corrugated web[J]. Journal of Architecture and Civil Engineering, 2006, 23(4):58-63(in Chinese).
[8] 李靓姣. 波浪形钢板墙的受力性能及设计方法研究[D]. 北京:清华大学土木工程系, 2012.
Li Liangjiao. Research on Behavior and Design Methods of Sinusoidal Steel Plate Wall[D]. Beijing:Department of Civil Engineering, Tsinghua University, 2012(in Chinese).
[9] Kheirikhah M M, Babaghasabha V. Bending and buckling analysis of corrugated composite sandwich plates [J]. Journal of the Brazilian Society of Mechanical Sciences & Engineering, 2016, 38(8):1-18.
[10] Farzampour A, Laman J A, Mofid M. Behavior prediction of corrugated steel plate shear walls with openings[J]. Journal of Constructional Steel Research, 2015, 114(8):258-268.
[11] 陶旭. 导管架平台生活楼波纹板承载力数值模拟研究[D]. 天津:天津大学建筑工程学院, 2017.
Tao Xu. Numerical Studies on Bearing Capacity of Corrugated Plateused in Living Quarter for Jackets[D]. Tianjin:School of Civil Engineering, Tianjin University, 2017(in Chinese).
[12] 李润野. 导管架生活楼组块SPMT装船过程分析研究[D]. 天津:天津大学建筑工程学院, 2017.
Li Runye. SPMT Support Analysis of Jacket Living Quarter Transportation[D]. Tianjin:School of Civil Engineering, Tianjin University, 2017(in Chinese).
[13] Ji Huidi, Cui Weicheng, Zhang Shengkun. Ultimate strength analysis of corrugated bulkheads considering influence of shear force and adjoining structures[J]. Journal of Constructional Steel Research, 2001, 57(5):525-545.
[14] Paik J K, Seo J K. Nonlinear finite element method models for ultimate strength analysis of steel stiffened-plate structures under combined biaxial compression and lateral pressure actions—Part I:Plate elements[J]. Thin-Walled Structures, 2009, 47(8):1008-1017.
[15] American Petroleum Institute. RP 2A-WSDRecommended Practice for Planning, Designing and Constructing Fixed Offshore Platforms:Working Stress Design[S]. Washington DC:API Publishing Services, 2012.
[16] Det Norske Veritas. RU-SHIPDNV Rules for Classification of Ships[S]. Norway:Det Norske Veritas, 2015.

备注/Memo

备注/Memo:
收稿日期: 2017-03-02; 修回日期: 2017-11-27.
作者简介: 朱本瑞(1986—), 男, 博士, 讲师, zhubenrui@163.com.
通讯作者: 韩文秀, MZJQ2@126.com.
基金项目: 国家自然科学基金青年科学基金资助项目(No.,51509184).
Supported by the Young Scientists Fund of the National Natural Science Foudation of China(No.,51509184).
更新日期/Last Update: 2018-05-10