|本期目录/Table of Contents|

[1]崔云,陈刚,王磊,等.多轴非比例载荷下镁合金AZ21的疲劳性能研究[J].天津大学学报(自然科学版),2017,(03):283-289.[doi:10.11784/tdxbz201512051]
 Cui Yun,Chen Gang,Wang Lei,et al.Fatigue Characteristics of Mg Alloy AZ21 Under Multiaxial Non-Proportional Loading[J].Journal of Tianjin University,2017,(03):283-289.[doi:10.11784/tdxbz201512051]
点击复制

多轴非比例载荷下镁合金AZ21的疲劳性能研究()
分享到:

《天津大学学报(自然科学版)》[ISSN:0493-2137/CN:12-1127/N]

卷:
期数:
2017年03
页码:
283-289
栏目:
化学工程
出版日期:
2017-03-23

文章信息/Info

Title:
Fatigue Characteristics of Mg Alloy AZ21 Under Multiaxial Non-Proportional Loading
作者:
崔云12 陈刚1 王磊1 高红1 陈旭1
1. 天津大学化工学院,天津 300072;2. 天津大学仁爱学院,天津 301636
Author(s):
Cui Yun 12 Chen Gang1 Wang Lei1 Gao Hong1 Chen Xu 1
1.School of Chemical Engineering and Technology, Tianjin University, Tianjin 300072, China
2.Renai College of Tianjin University, Tianjin 301636, China
关键词:
低周疲劳 多轴疲劳 镁合金 非比例加载 疲劳寿命预测
Keywords:
low-cycle fatigue multiaxial fatigue Mg alloy non-proportional loading fatigue life prediction
分类号:
O346.2
DOI:
10.11784/tdxbz201512051
文献标志码:
A
摘要:
镁合金作为结构件承受多轴复杂载荷, 其失效形式多为多轴疲劳失效.本文在空气环境中对镁合金AZ21分别进行了单轴、纯扭以及多轴循环力学性能研究, 揭示了不同加载路径下材料的变形主导机制.疲劳试验结果表明, 在相同等效应力幅下, 非比例加载路径下镁合金AZ21的寿命较单轴、纯扭路径显著降低.采用Basquin公式预测镁合金AZ21在复杂载荷下的疲劳寿命.通过将路径非比例度的概念引入到Basquin公式中, 可合理预测相同加载幅值下圆形路径和菱形路径作用时镁合金AZ21的疲劳寿命.
Abstract:
Widely used for engineering structural components,Mg alloys are normally subjected to complicated multiaxial loads,and generally suffer multiaxial fatigue failure. In this study,the cyclic mechanical properties of the Mg alloy AZ21 were investigated under uniaxial,torsional and multiaxial loading paths in air. The dominant defor-mation mechanisms were revealed under different loading paths. The fatigue testing results showed that with the same equivalent stress amplitude,the fatigue lives under multiaxial non-proportional loading paths were much shorter than those under uniaxial and torsional loading paths. Basquin equation was used to predict the fatigue life of the Mg alloy AZ21 under complex loading paths. By introducing a non-proportionality factor into Basquin equation,reasonable life predictions of the Mg alloy AZ21 were achieved for the circular and rhombic paths with the same loading amplitude.

参考文献/References:

[1] 陈晓强, 刘江文, 罗承萍. 高强度Mg-Zn系合金的研究现状与发展趋势[J]. 材料导报, 2008, 22(5):58-62.
Chen Xiaoqiang, Liu Jiangwen, Luo Chengping. Research status and development trend of Mg-Zn alloys with high strength[J]. Materials Review, 2008, 22(5):58-62(in Chinese).
[2] Arruebarrena G, Hurtado I, V?in?l? J. et al. Develop-ment of investment-casting process of Mg-alloys for aerospace applications[J]. Advanced Engineering Materials, 2007, 9(9):751-756.
[3] Wu F, Zhang S, Tao Z. Corrosion behavior of 3C magnesium alloys in simulated sweat solution[J]. Materials and Corrosion, 2011, 62(3):234-239.
[4] Gao L, Luo A A. Hot deformation behavior of as-cast Mg-Zn-Mn-Ce alloy in compression[J]. Materials Science and Engineering:A, 2013, 560:492-499.
[5] Seuss F, Seuss S, Turhan M C, et al. Corrosion of Mg alloy AZ91D in the presence of living cells[J]. Journal of Biomedical Materials Research Part B:Applied Biomaterials, 2011, 99(2):276-281.
[6] Lin Y C, Liu Z H, Chen X M, et al. Uniaxial ratcheting and fatigue failure behaviors of hot-rolled AZ31B magnesium alloy under asymmetrical cyclic stress-controlled loadings[J]. Materials Science and Engineering:A, 2013, 573(3):234-244.
[7] Albinmousa J, Jahed H. Multiaxial effects on LCF behaviour and fatigue failure of AZ31B magnesium extrusion[J]. International Journal of Fatigue, 2014, 67(4):103-116.
[8] Zhang J, Yu Q, Jiang Y, et al. An experimental study of cyclic deformation of extruded AZ61A magnesium alloy[J]. International Journal of Plasticity, 2011, 27(5):768-787.
[9] Yu Q, Zhang J, Jiang Y, et al. Multiaxial fatigue of extruded AZ61A magnesium alloy[J]. International Journal of Fatigue, 2011, 33(3):437-447.
[10] Wu L, Jain A, Brown D W, et al. Twinning-detwinning behavior during the strain-controlled low-cycle fatigue testing of a wrought magnesium alloy, ZK60A[J]. Acta Materialia, 2008, 56(4):688-695.
[11] Wu W, An K, Huang L, et al. Deformation dynamics study of a wrought magnesium alloy by real-time in situ neutron diffraction[J]. Scripta Materialia, 2013, 69(5):358-361.
[12] Wu W, Liaw P K, An K. Unraveling cyclic deformation mechanisms of a rolled magnesium alloy using in situ neutron diffraction[J]. Acta Materialia, 2015, 85(15):343-353.
[13] Socie D. Multiaxial fatigue damage models[J]. Journal of Engineering Materials and Technology, 1987, 109(4):293-298.
[14] Chen X, Song J, Kim K S. Low cycle fatigue life prediction of 63Sn-37Pb solder under proportional and non-proportional loading[J]. International Journal of Fatigue, 2006, 28(7):757-766.
[15] Yu Q, Zhang J, Jiang Y, et al. Effect of strain ratio on cyclic deformation and fatigue of extruded AZ61A magnesium alloy[J]. International Journal of Fatigue, 2012, 44(9):225-233.
[16] 陈刚, 鲁灵涛, 崔云, 等. AZ31B的单轴棘轮和在线腐蚀疲劳性能研究[J]. 天津大学学报:自然科学与工程技术版, 2016, 49(8):790-796.
Chen Gang, Lu Lingtao, Cui Yun, et al. Ratcheting and low-cycle fatigue characterizations of AZ31B with corrosive environment[J]. Journal of Tianjin University:Science and Technology, 2016, 49(8):790-796(in Chinese).
[17] 黄洪涛. AZ31镁合金塑性变形机制及再结晶行为的研究[D]:北京:清华大学材料科学与工程学院, 2013.
Huang Hongtao. Research on Plastic Deformation Mechanism and Recrystallization of AZ31 Magnesium Alloy[D]. Beijing:School of Materials Science and Engineering, Tsinghua University, 2013 (in Chinese).
[18] Wu W, Qiao H, An K, et al. Investigation of deform-ation dynamics in a wrought magnesium alloy[J]. International Journal of Plasticity, 2014, 62(12):105-120.
[19] Albinmousa J, Jahed H, Lambert S. Cyclic axial and cyclic torsional behaviour of extruded AZ31b magnesium alloy[J]. International Journal of Fatigue, 2011, 33(11):1403-1416.
[20] Liu Y, Kang G, Gao Q. A multiaxial stress-based fatigue failure model considering ratchetting-fatigue interaction[J]. International Journal of Fatigue, 2010, 32(4):678-684.

相似文献/References:

[1]陈旭,张源,安柯,等.14MnNbq钢焊接接头低周疲劳性能[J].天津大学学报(自然科学版),2001,(03):386.
[2]赵小辉,王东坡,邓彩艳,等.火焰喷熔涂层与焊接接头性能研究[J].天津大学学报(自然科学版),2012,(03):254.
 ZHAO Xiao-hui,WANG Dong-po,DENG Cai-yan,et al.Spray Fused Coating and Properties of Welded Joints[J].Journal of Tianjin University,2012,(03):254.
[3]陈刚,鲁灵涛,崔云,等.AZ31B在腐蚀环境下的棘轮与低周疲劳性能研究[J].天津大学学报(自然科学版),2016,(08):790.[doi:DOI:10.11784/tdxbz201503029]
 Chen Gang,Lu Lingtao,Cui Yun,et al.Ratcheting and Low-Cycle Fatigue Characteristics of AZ31B Under Corrosive Environment[J].Journal of Tianjin University,2016,(03):790.[doi:DOI:10.11784/tdxbz201503029]

备注/Memo

备注/Memo:
收稿日期: 2015-12-14; 修回日期: 2016-04-22.
作者简介: 崔云(1978—), 女, 硕士, 高级工程师.
通讯作者: 王磊, anewlife@163.com.
网络出版时间: 2016-06-22.网络出版地址: http://www.cnki.net/kcms/detail/12.1127.N.20160622.1050.002.html.
基金项目: 国家自然科学基金资助项目(11172202); 教育部新世纪优秀人才资助项目(NCET-13-0400).
Supported by the National Natural Science Foundation of China(No.,11172202) and the Program for New Century Excellent Talents in Universities of Ministry of Education, China(No.,NCET-13-0400).
更新日期/Last Update: 2017-03-10